Support

FAQs

Yes, all models of Kaldewei bath are very suited to be under-mounted or flush-mounted, as they have unparalleled stability and durability. 

Technically, any Kaldewei baths can be used as a shower over bath, however there some better than others from a practical point of view.

A bath with its waste at one end rather than centred, is best. 

Baths that have a generous width and a flatter surface area at the waste end are recommended.

Models we suggest are: Dyna Set, Cayono, Cayono Wide, Puro and Vaio Set. All of these models are available in different lengths to suit your space.

No. However, Kaldewei recommends using the leg system, as it makes installation fast and simple and separates the bath from the concrete slab allowing for thermal insulation of the bath for greater heat retention of the water.

The Overflow stops the level of the water from over-flowing the rim when filling the bath.

The Multifiller has the same functionality of an overflow. It also replaces the need for a wall-mounted spout as the water fills the bath from the overflow. A separate mixer to control the temperature and flow of the water is required.

Both include a pop-up plug & waste.

The Bathe showroom in Sydney is by appointment only, please contact Bathe on phone 02 9509 0000 to set up an appointment or find a retailer in your local area here: https://www.bathe.net.au/find-a-retailer/

Our lead times vary depending on brand. We stock a huge range of products in our Sydney warehouse, if the item is not a stocked line the lead times are as follows by brand;

KALDEWEI – 12-16 weeks (depending on factory availability)

FIMA – 8-10 weeks

GLOBO – 12-16 weeks, depending on colour choice

AQUAS – all items listed are IN STOCK,  if we have run out at any given time there are always more on the way.

MULTIPOINT SPAS – Chrome = 3-4 weeks, Colour jets = 5-6 weeks

To put in a warranty claim you must contact the retailer where the product was purchased and provide them with proof of purchase and details of the issue. Photo images may also be requested.

Yes. All models and ranges listed on the Bathe website products are Watermark certified and WELS approved where applicable. Note; if you go on the brand’s overseas website, models and ranges not on Bathe’s website, may be found and may not be certified for Australian installation.

No, Bathe is strictly a wholesale operator and cannot supply direct to the consumer unless it is a “Clearance item” which are available from our website within the Shop.

Baths must be installed as per the Australian Building Code. This standard provides guidance on different installation options depending on what is required.

Tile trim is no longer supplied with baths, as it is not required to meet Australian Standards.

Need to ask us a Question?

Our Customer Service team is available Monday – Friday between 8.30am and 5pm

Continue Shopping

Your Cart